Audimage - Products

Return to BP 20/25

BP 20/25 Series Technical Specifications
Frequency Response:	20Hz-20kHz +/- .05dB
Maximum Output:	15 volts unbalanced, 30 volts balanced
IM or THD:	<0.0015% at 3 volts out
High Level Intensity:	500mV
Rated Noise:	Ref. 500mV unbalanced input, 20-20kHz - 100dB Ref. 1 volt balanced input 20-20kHz - 103dB
XLR:	Pin 1 ground, pin 2 positive, pin 3 negative
Features:	2 pair balanced female XLR inputs 1 pair balanced male XLR outputs 5 pair RCA inputs 4 pair RCA + 1 pair phono inputs (BP-20/25P and BP-20/25MC only) 4 pair RCA + 2 SPDIF digital inputs (BP20/25 DA only) 2 pair RCA outputs 1 tape loop Silver or black faceplate
Dimensions:	17 or 19" x 1.75 x 11", 43.18 or 48.26 x 4.44 x 28 cm
Weight:	17 lbs, 7.5 kg

BP20/25 DA Specifications

Input Sample Rate: 16kHz to 108kHz.

Word Length: 16, 18, 20, 24 Bit

Conforms to SPDIF standard

Distortion: Less than .002%, 20Hz-20kHz

Signal to Noise Ratio: > 100dB

Frequency Response: 20Hz-20kHz +/- .1dB

BP 20/25P Phono Specifications

Distortion: Less than .005%, IM or THD, any frequency or combination of frequencies from 20-20kHz, at rated output or below

Rated Noise: Phono: -80dBA referred to an input of 5 millivolts RMS @ 1kHz

RIAA Accuracy: Within less than +/- 0.05dB from 20-20kHz inclusive

BP-25MC Phono Specifications

Distortion: Less than .005%, 20-20kHz, with preamplifier driven to full rated output

Noise: Equivalent to approximately 1000 ohm metal film register (Thermal noise greater than 85dB below 0.6mV input, unweighted)

Gain: 16.5 or 22.5dB (internally restrappable)

Frequency Response: Below 5Hz to above 30kHz, within less than +/- 0.5dB